Pristine Cleaning Gurus Logo

How to Remove Soap Scum From the Tub and Tile Walls

4 min readPristine Cleaning Gurus Team
Clean white bathtub and tile after a Pristine Cleaning Gurus bathroom clean

The Short Answer

Soap scum is a waxy film, and wax needs a degreaser, not a bigger scrub. Warm water, dish soap and a non-scratch sponge take off a fresh layer. A paste of baking soda and water helps with the older, gray buildup on a tub and tile walls.

If your tub feels rough or looks dull even after you rinse it, that is scum. If a crust is mixed in, it is also hard water, and we cover that in our hard water stains guide.

Rather have us handle it?

We clean homes and businesses in Jacksonville, Jacksonville Beach, Ponte Vedra, Fernandina Beach, Yulee and St. Augustine.

Step by Step for a Tub and Tile Walls

  1. Run hot water first. Warm the tub and walls for a minute so the film softens.
  2. Apply dish soap. Squeeze a little onto a damp non-scratch sponge, or mix a few drops into a spray bottle of warm water. Cover the walls from the bottom up so streaks do not run down onto clean spots.
  3. Let it sit for 5 to 10 minutes. This is the part people skip. The soap does the loosening.
  4. Scrub in small circles. For stubborn spots, sprinkle baking soda on the sponge and rub gently. Use a soft brush on the grout lines and around the drain.
  5. Rinse top to bottom with warm water. Soap left behind just starts the next layer.
  6. Dry with a towel or squeegee. Dry surfaces do not hold onto scum or water spots.

The tub has a few extra steps, like the drain, the overflow and the non-slip strips. Those are in our bathtub guide.

What Not to Use

  • Abrasive powder or steel wool on acrylic or fiberglass. It leaves fine scratches, and scratches hold more scum next time.
  • Acid on natural stone tile. If your shower walls are marble or travertine, keep vinegar and acid-based cleaners off. Use a stone-safe cleaner.
  • Bleach mixed with anything. Never mix bleach with ammonia or with vinegar or other acids. If you used a cleaner from a bottle, rinse fully before trying a different one, and run the bathroom fan.
  • Too much cleaner. More product does not mean more clean. It means more rinsing.

Always check the care instructions for your tub and test any new product on a hidden corner first.

How to Keep It From Building Back Up

  • Squeegee the walls for 30 seconds after the last shower of the day.
  • Leave the bathroom fan running for a while after you shower.
  • Switch to liquid body wash or a soap bar that rinses clean, if you have not.
  • Do a quick dish soap wipe of the tub once a week instead of a big scrub each month.

When to Hand It Off

If the buildup is thick, or the bathroom has not been scrubbed in a long time, a standard clean will not take it all the way down. Our deep cleaning adds grout on counters, backsplash and in the bathroom, and shower door tracks and caulk lines, on top of the standard tub and shower scrub.

You do not need to pre-clean. Just clear your counters so we have full access. Call (904) 469-1035.

Frequently Asked Questions

What is soap scum made of?
Mostly the leftovers of bar soap and body wash mixed with minerals from the water and a bit of body oil. It dries into a dull, waxy film.
Is soap scum the same as hard water stains?
No. Soap scum is greasy and soft, so it needs a degreasing cleaner. Hard water stains are mineral crust and need a mild acid. Many tubs have both.
Does liquid body wash leave less scum than bar soap?
Many people find it does, since bar soap is the usual culprit. It depends on your water and your products, so try it and see.

Scrubbing the Tub Again?

Our deep clean includes grout in the bathroom and shower door tracks and caulk lines. Request a free estimate.