The Short Answer
Sweep or vacuum, mop with warm water and a little cleaner, change the water when it turns gray, and rinse. Most tile floors look dull because of leftover soap and dirty water, not because the tile is worn out.
Tile itself is tough. The grout between it is what holds dirt and moisture.
Rather have us handle it?
We clean homes and businesses in Jacksonville, Jacksonville Beach, Ponte Vedra, Fernandina Beach, Yulee and St. Augustine.
Step by Step
- Sweep or vacuum well. Get the edges and corners. Loose grit scratches glazed tile.
- Fill a bucket with warm water. Add a small squirt of dish soap or a neutral tile cleaner. More soap does not clean better.
- Mop in sections. Wring the mop out well. Work away from the door you plan to leave through.
- Change the water. When it looks cloudy, dump it and start fresh.
- Rinse with plain water. A second pass with clean water lifts the soap film.
- Let it dry or buff it. A dry towel stops water spots.
Dealing With the Grout Lines
If the grout is still gray after mopping, spread a paste of baking soda and water on the lines, wait a few minutes and scrub with a stiff nylon brush. Rinse well. Our guide to cleaning grout has the full steps.
Ready to get started?
What to Avoid
- Acids on natural stone. Marble, limestone and travertine can etch. Skip vinegar on those.
- Mixing cleaners. Never bleach with ammonia or vinegar.
- Wire brushes and steel wool. They scratch tile and grout.
- Too much cleaner. It leaves a sticky film that attracts dirt.
- Slick floors. Wet tile is slippery, so keep kids and pets off until it dries.
How Often and When to Hand It Off
Sweep a few times a week and mop weekly in busy areas. Sand tracked in from the beach is the main thing that dulls tile around here. Our deep cleaning includes grout on counters, backsplash and in the bathroom, and our residential cleaning includes floors vacuumed or mopped. Call (904) 469-1035 for a free estimate.